Natio Ambient Essential Oil Diffuser

Natio Ambient Essential Oil Diffuser

INSTRUCTIONS: 

1. Place diffuser on a flat surface and remove the glass cover and then the water tank inner lid. Ensure diffuser is not running and power source is turned off.
2. Using a small cup, fill water tank with cool tap water, to the MAX water level line.
3. Add 6-10 drops of your favourite Pure Essential Oil or Blend.
4. Replace the lid and glass cover.
5. Plug in cable to the base of diffuser and then turn on the power source.
6. Press LIGHT button on the right to turn on Bright light mode. Press button again to change to Soft light mode. Press button again (3rd time) to change to Breathing light mode.
7. To activate sleeping light mode, hold down both LIGHT and MIST buttons for 2 seconds until the 3 lights on the base flash from left to right. Lights will turn off after 30 minutes. This function will only turn on when lights are on Bright or Soft mode and not Breathing mode.
8. To turn off the lights, press and hold the button for 4 seconds.
9. Press MIST button on the left to start diffusion. Press the MIST button once to change mist setting. To set the diffuser on a 1-hour timer, press MIST button twice. Press the MIST button again to set it on 3 hours and again for 8 hours. The lights under each number will appear for about 10 seconds.
10. To turn off the diffuser, press and hold the MIST button until the diffuser stops misting.

Cleaning Instructions:

Turn off power source and unplug cable from base of diffuser. 
Remove cover and/or lid and empty water from water tank from the DRAIN side.
Mix a small amount of soap with warm water in a separate bowl and use a clean cloth to wipe and clean the inside of the water tank and hood with the soapy water.
To best enjoy your diffuser, wipe and clean it after each use. Ensure the inside of the air inlet is free from dirt and dust.
DO NOT use diluted alcohol, ethanol or corrosive chemicals for cleaning as this will damage diffuser.

Safety Instructions:

Only add Pure Essential Oils or Blends to water when diffusing. Do NOT add other chemicals, spices, impurities or any other oils or fragrances as it may cause toxic or fire risk when diffusing.
If the diffuser tips over accidentally, turn off power source immediately. Unplug the cable and remove the cover and/or lid. Empty water from DRAIN side of water tank. Gently shake unit and position it so that it is in a safe upright position to dry for 24 hours before diffusing again.
Keep the diffuser away from hazards such as electrical appliances, unstable or wet surfaces, air conditioning or fans, and direct sunlight and heat.
Please note that diffuser will automatically shut off when the water runs out.